Graphic Attributes

Each graphic attribute can be set by the class style or to specific settings. If set by the class style, the attributes are controlled by the class selected in the Roof Framer dialog box for the framing element.

Fill

Select Class Style to use the class style for the fill attribute, choose None to apply no fill, or choose a fill style

Pen

Select Class Style to use the class style for the pen attribute, choose None to apply no pen, or choose a solid/dash or pattern style

Line Thickness

Select Class Thickness to use the class style for the line thickness attribute, choose Set Thickness to specify the line thickness, or select a line thickness

Texture (Renderworks required)

Select Class to use the class texture for the framing element (see Applying Object Textures by Class), choose None to apply no texture, or choose Select to set the texture parameters

Texture

Select the texture to apply from either the default content or the current file’s content; see Resource Libraries

Map Type

Select the texture map type

Radius

For sphere and cylinder maps, sets the texture radius; the default radius is the same as the 3D object radius. Increasing this value reduces the size of the texture on the object.

Start/End Cap

Applies the texture to the start and end caps of the framing element

Repeat Horizontally/ Vertically

Repeats the texture in a horizontal and/or vertical direction

Scale Factor

Enter a scale value to determine the texture size when projected onto the object

Horizontal/Vertical Offset

Sets the start location of the texture horizontally and vertically

Rotation

Sets the angle of texture rotation; enter a rotation value from 0 to 360 degrees