Selection and Pre-selection Indicators

When you move the cursor over the objects in a drawing, and when you select objects, highlighting and handles provide information about the current state of the objects. These indicators can be customized as needed in the Vectorworks preferences. See Interactive Preferences for details.

Highlighting

Highlighting can indicate the following information about an object in a drawing.

     Currently selected

     Currently “pre-selected” because it is under the cursor (or within the selection marquee)

     Locked

     On an inactive layer

     Causing one of the displayed “snap points”

     Can be acted upon by the currently active tool

In the Vectorworks preferences, there are several options to customize the highlighting.

     The different types of highlighting can be enabled and disabled individually.

     The highlighting for selected objects can be animated.

     The timing of the highlighting for pre-selected objects can be adjusted.

     The color, opacity, and size of each type of highlighting can be adjusted.

By default, all highlighting options are enabled, and selected objects display as shown in the following illustration.

hilight_samples.png 

In a rendered 3D view, solid objects “occlude” or hide objects behind them. Highlighting of occluded objects is set, by default, to be less opaque than that of objects not occluded behind other objects.

Occluded_highlighting.png 

Handles

In addition to highlighting, square “handles” can display on selected objects. The appearance of the handles is controlled by the Selection highlighting setting on the Interactive tab in the Vectorworks preferences. Also, the colors of the handles can be customized.

If selection highlighting is enabled (the default setting):

     Handles display on a selected object if the object can be edited with the active tool

     Unlocked objects on the active layer have blue handles

     Unlocked objects on an inactive layer have white handles

     Locked objects have no handles (since they cannot be edited)

     Handles can be used as reshape points

If selection highlighting is disabled:

     Handles display on all selected objects

     Unlocked objects on the active layer have blue handles

     Locked objects on the active layer have gray handles

     All objects on an inactive layer have white handles

     Some of the handles can be used as reshape points, and some cannot, depending on the object, and on which tool is active

Basic100040.png 

~~~~~~~~~~~~~~~~~~~~~~~~~

Configuring Interactive Display

Selecting Objects

 

www.vectorworks.net